|
17 of 19 people found the following review helpful: By frankosonik (Illinois) - See all my reviews This review is from: Waring JEX450 Pulp-Eject Juice Extractor, Brushed Stainless (Kitchen) I just got one for Christmas, and have been happy with the product. I only had to use 'extreme force' if I put too much food into the chute at once. I've been juicing pineapples and apples for a few days now and have not experienced an overheating problem. Also, compared to other juicers I've had (juiceman, etc), this one is simple to clean. 9 of 10 people found the following review helpful: By This review is from: Waring JEX450 Pulp-Eject Juice Extractor, Brushed Stainless (Kitchen) I waited until I'd had mine for a month, to make sure I wasn't missing some problem, but I haven't discovered a single one. I make large quantities of juice nearly every day, and in my view this juicer is efficient and simple to clean. It hasn't overheated, and it's handled every fruit I put in it with no hassle. I do tend to be careful not to overstuff the feed chute, but I've juiced whole apples without a hitch. I consider it a great buy for the money. 31 of 40 people found the following review helpful: By Bund Pan Collector (North Carolina) - See all my reviews This review is from: Waring JEX450 Pulp-Eject Juice Extractor, Brushed Stainless (Kitchen) I recently purchased the NEW Waring juice simply because I knew the name and quality of products they typically produce. This juicer does have a larger feed chute which makes juicing easier but there are these three metal bars inside to prevent people from sticking their hand in machine. These bars obviously are there for safety but caused my food push to get stuck in the machine while juicing spinach and created a suction action. I had to wiggle and use EXTREME force to extract the food push from the machine. I also tried to juice pineapple and green apples, two of my favorites but the machine over heated. I had to follow the instructions in the manual that covered overheating throughly, now I know why they devoted so much time to overheating as this happened twice with me. I could only proceed after unplugging the machine and waiting 5 minutes with no luck, and then after ten minutes I was ready to go again. Also noticed that the pulp container had large...Read more |